Gmc P35 recalls by model year

Reported: 1978-09-26 (September 26, 1978) · Model years: 1978

THE PARKING BRAKE SWITCH CONNECTOR CONTAINS ELECTRICAL WIRES THAT MAY BE REVERSED. AS A RESULT, THE LAMP WILL BE ACTIVATED WHENEVER THE IGNITION IS TURNED ON, EVEN THOUGH THE PARKING BRAKE IS NOT ENGAGED. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS". THE STANDARD REQUIRES THAT THE INDICATOR LAMP BE ACTIVATED UPON APPLICATION OF THE PARKING BRAKE.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, CORRECT THE PARKING BRAKE SWITCH WIRING WITHOUT CHARGE TO OWNER.

Reported: 1978-09-26 (September 26, 1978) · Model years: 1978

THE INVOLVED VEHICLES DO NOT HAVE A BRAKE FLUID RESERVOIR WARNING WHICH STATES, "WARNING, CLEAN FILLER CAP BEFORE REMOVING. USE ONLY DOT 3 FLUID FROM A SEALED CONTAINER". THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS".

Remedy: THE DEALER WILL INSTALL THE BRAKE FLUID RESERVOIR WARNING PLATE WITHOUT CHARGE TO OWNER.

Reported: 1978-09-26 (September 26, 1978) · Model years: 1978

THE FUEL TANK FUSIBLE BUSHING ELEMENT MAY HAVE MELTED DUE TO EXTREMELY HIGH TEMPERATURES ENCOUNTERED WHEN THE TANKS WERE EXPOSED TO DIRECT SUNLIGHT RAYS DURING CHASSIS STORAGE.

Remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE FUEL TANK VENT PLUG WITHOUT CHARGE TO OWNER.

Reported: 1985-10-15 (October 15, 1985) · Model years: 1982, 1983, 1984, 1985

THE FAN BLADE, WHEN SUBJECTED TO HIGH STRESS LEVELS, CAN FATIGUE AND BREAK APART AT THE HUB WHILE THE ENGINE IS RUNNING. CONSEQUENCE OF DEFECT: IF BREAKAGE OCCURS WHILE HOOD IS OPEN, A PERSON WORKING UNDER THE HOOD OR NEAR THE TRUCK COULD BE STRUCK BY A BLADE PART AND BE INJURED.

Remedy: REPLACE ENGINE FAN.

Reported: 1984-10-16 (October 16, 1984) · Model years: 1984

DUE TO A MANUFACTURING PROBLEM WITH THE FUEL TANK FILLER PIPE, THE FUEL CAP MAY IMPROPERLY SEAL THE END OF THE FILLER PIPE. THIS FAILS TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY." IN THE EVENT OF A COLLISION, AN IMPROPERLY SEALED FILLER PIPE COULD ALLOW FUEL SPILLAGE.

Remedy: THE DEALER WILL INSPECT AND REPLACE FUEL CAPS ON ALL AFFECTED VEHICLES WITHOUT CHARGE.

Reported: 1986-08-25 (August 25, 1986) · Model years: 1984, 1985

THREE BOLTS WHICH ATTACH THE SILL THAT SUPPORTS THE BASE OF THE SEAT WERE OMITTED; THEREFORE VEHICLES DO NOT COMPLY WITH FMVSS 210 AND FMVSS 207. CONSEQUENCE OF DEFECT: IN THE EVENT OF A CRASH, THE FLOOR PLATE COULD BUCKLE ALONG THE INBOARD SIDE CAUSING THE SEAT PEDESTAL TO BE IMBALANCED, AND INCREASING THE LIKELIHOOD OF INJURY TO THE SEAT OCCUPANT.

Remedy: INSTALL MISSING BOLTS.

Reported: 1985-11-26 (November 26, 1985) · Model years: 1985

THE WHEEL MAY DEVELOP CRACKS BETWEEN THE DISC AND RIM. CONSEQUENCE OF DEFECT: IF THIS OCCURS AND IS NOT NOTICED, THE CRACK COULD INCREASE AROUND THE RIM, RESULTING IN SEPARATION OF THE RIM FROM THE DISC, LOSS OF CONTROL AND AN ACCIDENT MAY OCCUR.

Remedy: REPLACE WHEELS HAVING THE SUSPECTED MANUFACTURING CODE NUMBER.

Reported: 1986-08-18 (August 18, 1986) · Model years: 1985

DURING A COMBINED CORNERING AND BRAKING MANEUVER, THE TIE ROD END COULD CONTACT THE TIRE WALL. CONSEQUENCE OF DEFECT: THIS CONTACT CAN CAUSE GROOVING OF THE TIRE, WHICH COULD EVENTUALLY RESULT IN TIRE FAILURE AND POSSIBLY A VEHICLE CRASH WITHOUT PRIOR WARNING.

Remedy: REPLACE 16" WHEELS AND TIRES WITH 19 1/2" WHEELS AND TIRES; ALSO, REPLACE SPEEDOMETER GEAR TO COMPENSATE FOR NEW SIZE WHEELS AND TIRES.

Reported: 1990-02-12 (February 12, 1990) · Model years: 1987, 1988, 1989

SEAT PEDESTALS FOR DRIVER AND PASSENGERS MAY HAVE A LARGER THAN SPECIFIED SLOT IN THE CENTER CHANNEL.

Consequence: SEAT PEDESTAL MAY NOT MEET LOADING REQUIREMENTS OF FMVSS 210.

Remedy: REPLACE SEAT PEDESTALS WITH PEDESTALS HAVING PROPER SLOT SIZE.