| Engine | — | 3ODI 11612226While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present. Look up ODI 11612226 at NHTSA ↗ ODI 11658727Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix. Look up ODI 11658727 at NHTSA ↗ ODI 11576357After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantr… Look up ODI 11576357 at NHTSA ↗ | 3ODI 11612224While driving on the interstate, the car went into limp mode (does not rev above 2000 rpm). I was unable to maintain speed or merge back into interstate. The dealership has inspected the vehicle, however, they confirm everything is normal. The car did give an engine error code of P132600 for Powertrain. This is the second time this issue has occurred, the dealership replaced the knock sensor the first time. Look up ODI 11612224 at NHTSA ↗ ODI 11612226While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present. Look up ODI 11612226 at NHTSA ↗ ODI 11576357After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantr… Look up ODI 11576357 at NHTSA ↗ | 1ODI 11658727Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix. Look up ODI 11658727 at NHTSA ↗ | 0 | 0 | 0 | 0 |
|---|
| Electrical System | 3ODI 11612226While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present. Look up ODI 11612226 at NHTSA ↗ ODI 11658727Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix. Look up ODI 11658727 at NHTSA ↗ ODI 11576357After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantr… Look up ODI 11576357 at NHTSA ↗ | — | 2ODI 11612226While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present. Look up ODI 11612226 at NHTSA ↗ ODI 11576357After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantr… Look up ODI 11576357 at NHTSA ↗ | 2ODI 11548884Horn stopped functioning Look up ODI 11548884 at NHTSA ↗ ODI 11658727Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix. Look up ODI 11658727 at NHTSA ↗ | 0 | 0 | 0 | 0 |
|---|
| Power Train | 3ODI 11612224While driving on the interstate, the car went into limp mode (does not rev above 2000 rpm). I was unable to maintain speed or merge back into interstate. The dealership has inspected the vehicle, however, they confirm everything is normal. The car did give an engine error code of P132600 for Powertrain. This is the second time this issue has occurred, the dealership replaced the knock sensor the first time. Look up ODI 11612224 at NHTSA ↗ ODI 11612226While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present. Look up ODI 11612226 at NHTSA ↗ ODI 11576357After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantr… Look up ODI 11576357 at NHTSA ↗ | 2ODI 11612226While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present. Look up ODI 11612226 at NHTSA ↗ ODI 11576357After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantr… Look up ODI 11576357 at NHTSA ↗ | — | 0 | 0 | 0 | 0 | 0 |
|---|
| Unknown Or Other | 1ODI 11658727Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix. Look up ODI 11658727 at NHTSA ↗ | 2ODI 11548884Horn stopped functioning Look up ODI 11548884 at NHTSA ↗ ODI 11658727Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix. Look up ODI 11658727 at NHTSA ↗ | 0 | — | 0 | 0 | 1ODI 11557297Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced. Look up ODI 11557297 at NHTSA ↗ | 1ODI 11557297Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced. Look up ODI 11557297 at NHTSA ↗ |
|---|
| Fuel System, Gasoline | 0 | 0 | 0 | 0 | — | 0 | 0 | 0 |
|---|
| Fuel/Propulsion System | 0 | 0 | 0 | 0 | 0 | — | 0 | 0 |
|---|
| Steering | 0 | 0 | 0 | 1ODI 11557297Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced. Look up ODI 11557297 at NHTSA ↗ | 0 | 0 | — | 1ODI 11557297Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced. Look up ODI 11557297 at NHTSA ↗ |
|---|
| Suspension | 0 | 0 | 0 | 1ODI 11557297Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced. Look up ODI 11557297 at NHTSA ↗ | 0 | 0 | 1ODI 11557297Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced. Look up ODI 11557297 at NHTSA ↗ | — |
|---|