Mack MC recalls by model year

Reported: 1979-05-31 (May 31, 1979) · Model years: 1977, 1978, 1979

IN THE EVENT OF TURBOCHARGER COMPRESSOR WHEEL FAILURE, ONE OR MORE OF THE FOUR CAPSCREWS THAT HOLD THE TURBOCHARGER TOGETHER MAY BE STRUCK BY PARTS OF THE COMPRESSOR WHEEL, RESULTING IN THE CAPSCREWS BEING DAMAGED. IF THESE CAPSCREWS ARE DAMAGED TO THE POINT THAT THEY ALLOW THE COMPRESSOR BACK PLATE TO DISLOCATE FROM THE TURBOCHARGER BEARING HOUSING, ENGINE LUBRICATING OIL MAY BE ALLOWED TO ESCAPE UNDER PRESSURE, CONTACTING THE ENGINE EXHAUST MANIFOLD SECTIONS OR TURBOCHARGER TURBINE HOUSING.

Remedy: DEALER WILL INSTALL A SHIELD FOR THE HEADS OF THE FOUR CAPSCREWS, ALONG WITH STRONGER SAE 8 GRADE 8 CAPSCREWS, IF NECESSARY, AT NO COST TO OWNER.

Reported: 1979-01-09 (January 9, 1979) · Model years: 1978

A DEFICIENCY IN THE ROUTING OF THE HEATER DUCT HOSE COULD ALLOW THE HOSE TO REST AGAINST A TERMINAL POST OF THE ACCESSORY RELAY. VIBRATION WILL EVENTUALLY CAUSE THE TERMINAL POST TO PENETRATE THE HOSE FABRIC AND SHORT CIRCUIT THE WIRE REINFORCEMENT AND OVERLOAD THE CIRCUIT.

Remedy: DEALER WILL REPLACE THE PORTION OF THE EXISTING HOSE THAT IS CLOSEST TO THE ACCESSORY RELAY WITH AN ALL-RUBBER HOSE.

Reported: 1979-07-12 (July 12, 1979) · Model years: 1979

THE SPRING SEAT PLATE, LOCATED BETWEEN THE AXLE HOUSING AND THE SUSPENSION SPRINGS, MAY DEFORM DUE TO SPRING BENDING. AS A RESULT, THE CLAMPING FORCE IN THE ASSEMBLY MAY BE REDUCED. LOSS OF CLAMPING FORCE COULD CAUSE SPRING FAILURE AND THE AXLE WILL DISLOCATE. ALSO, THE TIRE COULD COME INTO CONTACT WITH THE SPRING.

Remedy: THE DEALER WILL REPLACE THE EXISTING SPRING SEAT WITH A NEWLY FABRICATED SEAT WHICH IS WELDED TO THE HOUSING. AN IMPROVED SPRING CLAMPING PLATE AND NEW SPRINGS WILL ALSO BE INSTALLED WITHOUT CHARGE.

Reported: 1994-02-15 (February 15, 1994) · Model years: 1987, 1988, 1989, 1990, 1991, 1992

FUEL INJECTION SYSTEM RECONFIGURATION TO COMPLY WITH ENGINE EMISSION STANDARDS CAUSE HIGHER ENGINE VIBRATION LEVELS WHICH LEAD TO EARLY WEAR AND COMPLETE FAILURE OF THE SECONDARY THROTTLE RETURN MECHANISM.

Consequence: IN THE EVENT THE PRIMARY THROTTLE RETURN FAILS, FAILURE OF THE SECONDARY THROTTLE RETURN SYSTEM WOULD NOT PROVIDE PROTECTION AGAINST LOSS OF THROTTLE CONTROL.

Remedy: A NEW PRODUCTION SECONDARY THROTTLE RETURN SYSTEM CONFIGURATION WILL BE INSTALLED.

Reported: 1994-10-09 (October 9, 1994) · Model years: 1990

THE STEERING ARM CAN DEVELOP CRACKS CAUSING THE LEVER TO BREAK WITHOUT WARNING.

Consequence: THIS CAN RESULT IN LOSS OF STEERING CONTROL AND AN ACCIDENT.

Remedy: DEALERS WILL REPLACE THE STEERING LEVERS WITH AN IMPROVED STEERING LEVER WITH INCREASED FATIGUE STRENGTH.