Mercury BOBCAT recalls by model year

Reported: 1978-06-19 (June 19, 1978) · Model years: 1975, 1976

IN THE EVENT THE VEHICLE IS STRUCK FROM THE REAR, THE FUEL FILLER PIPE COULD DISCONNECT FROM THE TANK OR THE TANK COULD BE PUNCTURED IN THE FORWARD FACE. THIS WOULD RESULT IN FUEL LEAKAGE.

Remedy: THE DEALER WILL INSTALL A LONGER FUEL FILLER PIPE HAVING AN IMPROVED SEAL. ALSO, A POLYETHYLENE SHIELD WILL BE INSTALLED ON THE FRONT OF THE FUEL TANK.

Reported: 1976-04-29 (April 29, 1976) · Model years: 1976

Reported: 1976-07-20 (July 20, 1976) · Model years: 1976

Reported: 1976-10-29 (October 29, 1976) · Model years: 1976

Reported: 1978-04-04 (April 4, 1978) · Model years: 1976

IN THE EVENT OF A FRONTAL IMPACT, FUEL LEAKAGE MAY OCCUR AT THE FUEL LINE TO FUEL PUMP CONNECTION IN THE ENGINE COMPARTMENT. THESE VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".

Remedy: DEALER WILL INSTALL A PAIR OF FRONT BUMPER BRACKET EXTENSION PLATES TO SUPPLY ADDED PROTECTION FOR THIS FUEL LINE CONNECTION.

Reported: 1976-09-14 (September 14, 1976) · Model years: 1977

Reported: 1983-03-01 (March 1, 1983) · Model years: 1977, 1978, 1979

THE FLEXIBLE BLADE ENGINE COOLING FAN BLADES MAY CRACK AND BREAK OFF. THIS MAY BE CAUSED BY HIGH BLADE STRESSES THAT CAN RESULT FROM VIBRATION DURING VEHICLE OPERATION.

Remedy: DEALER WILL REPLACE THE DEFECTIVE ENGINE COOLING FAN AT NO COST TO OWNER.

Reported: 1978-03-08 (March 8, 1978) · Model years: 1978

THE AUTOMATIC LOCKING REAR SEAT BELT RETRACTORS ON CERTAIN VEHICLES MAY FAIL TO LOCK DUE TO BINDING OF THE LOCKING PAWL AGAINST THE RETRACTOR HOUSING. THIS BINDING IS CAUSED BY RETRACTOR HOUSING DEFORMATION WHICH OCCURRED DURING ASSEMBLY. AS A RESULT THE PASSENGERS WOULD BE RESTRAINED ONLY BY THE FULLY EXTENDED BELT. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION".

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE ONE OR BOTH REAR SEAT BELT ASSEMBLIES FREE OF CHARGE.

Reported: 1979-01-09 (January 9, 1979) · Model years: 1979

SOME OF THE INVOLVED VEHICLES DO NOT HAVE THE HAIR PIN CLIP USED TO RETAIN THE PUSHROD TO THE BRAKE PEDAL PUSHROD PIN INSTALLED. IF THIS CLIP IS MISSING, THE PUSHROD MAY BECOME DISENGAGED FROM THE BRAKE PEDAL PUSHROD PIN.

Remedy: DEALERS WILL INSPECT VEHICLES FOR THE PRESENCE OF THIS HAIR PIN CLIP AND, IF NECESSARY, ANY MISSING PARTS WILL BE INSTALLED AT NO COST TO OWNER.