Pontiac 6000 recalls by model year

Reported: 1982-03-08 (March 8, 1982) · Model years: 1982

UNDER CERTAAIN CONDITIONS, THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND FUEL TANK FILLER VENT PIPE COULD FRACTURE. THE FRACTURE OF THESE CLAMPS COULD CAUSE FUEL LEAKAGE AT ANY OF THE FOUR PIPE TO HOSE CONNECTIONS. LEAKAGE CAN OCCUR DURING REFUELING, OR WHILE DRIVING, IF THE FUEL TANK IS ABOVE 3/4 FULL.

Remedy: DEALER WILL INSPECT AND REPLACE THE HOSE CLAMPS ON THE FUEL TANK FILLER PIPE AND VENT PIPE AT NO COST TO OWNER.

Reported: 1983-01-01 (January 1, 1983) · Model years: 1982

REAR BRAKE HOSES MAY HAVE BEEN MANUFACTURED INCORRECTLY WHEN THE METAL END FITTINGS WERE INSTALLED. SOME REAR BRAKE HOSES MAY SEPARATE FROM THE METAL END FITTINGS WHEN SUBJECTED TO THE PULLING FORCE SPECIFIED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES".

Remedy: THE DEALER WILL INSPECT AND REPLACE, IF NECESSARY, THE REAR BRAKE HOSES AT NO CHARGE TO OWNERS.

Reported: 1983-09-14 (September 14, 1983) · Model years: 1983

PARKING BRAKE CABLES CONTAIN INCORRECT SPRINGS. THESE SPRINGS FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC BRAKE SYSTEMS".

Remedy: DEALER WILL INSPECT AND INSTALL NEW REAR PARKING BRAKE CABLE IF NECESSARY.

Reported: 1983-10-13 (October 13, 1983) · Model years: 1983

THE BRAKE PROPORTIONER VALVES MAY BREAK AND SEPARATE FROM THE MASTER CYLINDER. THIS WOULD ALLOW BRAKE FLUID TO LEAK AND WOULD RESULT IN A PARTIAL LOSS OF THE BRAKE SYSTEM.

Remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE ALL SUSPECT VALVES.

Reported: 1984-02-06 (February 6, 1984) · Model years: 1984

SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION.

Remedy: INSPECTION OF SEAT BACK LOCKS WILL BE PERFORMED. LOCKS THAT HAVE BENT, BROKEN OR MISSING HOOKS WILL BE REPLACED.

Reported: 1984-04-23 (April 23, 1984) · Model years: 1984

VEHICLES MAY HAVE BEEN WIRED IMPROPERLY SO THAT THE TAILGATE LOCK CAN BE RELEASED WHEN THE VEHICLE IS NOT IN PARK OR IS IN MOTION.

Remedy: CORRECT OPERATION OF THE TAILGATE LOCK WILL BE VERIFIED. THE LOCK RELEASE SHOULD OPERATE ONLY WHEN VEHICLE IS IN PARK AND THE IGNITION SWITCH IS IN THE RUN POSITION. IF THIS IS NOT THE CASE, THE WIRING WILL BE CORRECTED.

Reported: 1985-03-29 (March 29, 1985) · Model years: 1984

THE FUEL SYSTEM MAY LEAK AT THE THROTTLE BODY INJECTION FUEL FEED PIPE CONNECTION. CONSEQUENCE OF DEFECT: THIS LEAKAGE COULD RESULT IN AN UNDERHOOD FIRE WHICH COULD SPREAD TO THE PASSENGER COMPARTMENT AND CAUSE BURN INJURIES TO OCCUPANTS.

Remedy: REPLACE THE FUEL FEED PIPE.

Reported: 1984-10-16 (October 16, 1984) · Model years: 1985

THE THROTTLE LINKAGE MAY BIND BECAUSE DURING NORMAL OPERATION, THE THROTTLE BODY CASE MAY INTERFERE WITH THE LINKAGE. THIS INTERFERENCE COULD PREVENT THE THROTTLE FROM CLOSING EVEN THOUGH THE DRIVER HAS REMOVED HIS FOOT FROM THE ACCELERATOR PEDAL.

Remedy: THE DEALER WILL INSPECT VEHICLES AND IMPROVE THE CLEARANCE BETWEEN THE ACCELERATOR LINKAGE AND THROTTLE BODY CASING IF NEEDED, AT NO CHARGE TO OWNER.

Reported: 1986-04-28 (April 28, 1986) · Model years: 1986

THE PUSH-PULL HEADLIGHT SWITCH MAY HAVE ELECTRICAL CONTACTS WHICH ALLOW AN INTERMITTENT HEADLIGHT CIRCUIT CAUSING HEADLIGHT TO FLICKER OR SUDDENLY GO OUT. CONSEQUENCE OF DEFECT: SUDDEN LOSS OF THE HEADLIGHTS UNDER SEVERE WEATHER OR NIGHTTIME DRIVING CONDITIONS COULD REDUCE DRIVER VISIBILITY WHICH MIGHT RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING. NOTE: ALSO, SEE NHTSA CAMPAIGN NUMBER 86V131000.

Remedy: REPLACE HEADLIGHT SWITCH AS NECESSARY.

Reported: 1986-09-19 (September 19, 1986) · Model years: 1986

THE PUSH PULL HEADLIGHT SWITCH MAY HAVE ELECTRICAL CONTACTS WHICH ALLOW AN INTERMITTENT HEADLIGHT CIRCUIT CAUSING HEADLIGHT TO FLICKER OR SUDDENLY GO OUT. CONSEQUENCE OF DEFECT: SUDDEN LOSS OF THE HEADLIGHTS UNDER SEVERE WEATHER OR NIGHTTIME DRIVING CONDITIONS COULD REDUCE DRIVER VISIBILITY WHICH MIGHT RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.

Remedy: REPLACE HEADLIGHT SWITCH AS NECESSARY.

Reported: 1987-06-23 (June 23, 1987) · Model years: 1986, 1987

THE ANTI LOCK BRAKE SYSTEM (ABS) PRESSURE/WARNING SWITCH MAY EXHIBIT BRAKE FLUID SEEPAGE WHICH EVENTUALLY CAN LEAD TO LOSS OF THE BRAKE SYSTEM HYDRAULIC PUMP MOTOR. ADDITIONALLY, THE HYDRAULIC PUMP MOTOR AND ABS ELECTRICAL RELAYS MAY HAVE BEEN EXPOSED TO WATER CONTAMINATION DURING VEHICLE ASSEMBLY. THIS CONDITION CAN CAUSE LOSS OF THE HYDRAULIC PUMP MOTOR AND/OR LOSS OF THE ABS FUNCTION.

Consequence: LOSS OF THE HYDRAULIC PUMP MOTOR WOULD RESULT IN A TOTALLOSS OF REAR BRAKES AS WELL AS POWER ASSIST TO THE FRONT BRAKES. THE RED BRAKEWARNING LIGHT WOULD ILLUMINATE AND STAY ON. IF THIS WARNING IS NOT HEEDED, ALOSS OF REAR BRAKES AT A TIME WHEN MINIMUM STOPPING DISTANCE IS REQUIRED COULDRESULT IN A VEHICLE CRASH. AN INOPERATIVE ABS ELECTRICAL RELAY COULD CAUSELOSS OF THE ABS FUNCTION, BUT NORMAL POWER ASSISTED BRAKING WOULD BE RETAINED.THE AMBER ANTI LOCK WARNING LIGHT WOULD ILLUMINATE AND STAY ON.

Remedy: THE ABS AND HYDRAULIC PUMP MOTOR ELECTRICAL RELAYS AND 30 AMP FUSES WILL BE REPLACED. IN ADDITION, THE HYDRAULIC PUMP MOTOR ASSEMBLY AND PRESSURE/WARNING SWITCH WILL BE INSPECTED AND, IF REQUIRED, REPLACED.

Reported: 1987-03-16 (March 16, 1987) · Model years: 1987

POOR BOND ADHESION BETWEEN THE WINDSHIELD GLASS AND MOUNTING COULD ALLOW THE WINDSHIELD TO SEPARATE DURING A 30 MPH FRONTAL BARRIER TEST REQUIRED BY FMVSS 212.

Consequence: IF WINDSHIELD GLASS SEPARATION OCCURS DURING ANACCIDENT, AN UNBELTED OCCUPANT COULD BE EJECTED FROM THE VEHICLE AND INJURED.

Remedy: REINSTALL WINDSHIELDS TO ASSURE PROPER BOND ADHESION.

Reported: 1988-04-01 (April 1, 1988) · Model years: 1988

FRONT SUSPENSION LOWER CONTROL ARM BRACKET COULD DEVELOP METAL CRACKS.

Consequence: THESE CRACKS MAY RESULT IN DISENGAGEMENT OF THE LOWERCONTROL ARM. IF THIS OCCURS WHILE VEHICLE IS IN MOTION, IT COULD RESULT INLOSS OF STEERING CONTROL AND A VEHICLE CRASH COULD OCCUR WITHOUT PRIOR WARNING.

Remedy: INSPECT ALL VEHICLES AND REPLACE ENGINE CRADLE ASSEMBLY ON ALL SUSPECT VEHICLES.

Reported: 1988-10-18 (October 18, 1988) · Model years: 1988

FUEL FEED HOSE COULD LEAK AT THE COUPLING ON THE ENGINE END OF THE HOSE ASSEMBLY.

Consequence: FUEL LEAKAGE INTO THE ENGINE COMPARTMENT COULD RESULT INAN ENGINE COMPARTMENT FIRE THAT COULD SPREAD TO THE PASSENGER COMPARTMENT.

Remedy: INSTALL NEW FUEL FEED HOSE ASSEMBLY.

Reported: 1995-09-15 (September 15, 1995) · Model years: 1989, 1990, 1991

THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.

Reported: 1992-09-01 (September 1, 1992) · Model years: 1990, 1991

THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT.

Consequence: THE HIGH CURRENT CAUSED BY THE ELECTRICAL SHORT WELDS THECIRCUIT BREAKER ELEMENTS TOGETHER IN THE CLOSED POSITION, LEAVING THE CIRCUITUNPROTECTED AND GENERATING SUFFICIENT HEAT TO BURN THE WIRE INSULATION ANDIGNITE THE SEAT CUSHION MATERIAL.

Remedy: REPAIR ANY ABRADED WIRING AND REROUTE THE WIRING HARNESS USING A WIRING HARNESS CLIP.