1978 Ford F100: complaints, problems and recalls

Reported: 1977-10-12 (October 12, 1977)

THE PITMAN ARM TO STEERING GEAR ATTACHMENT NUTS MAY NOT HAVE BEEN PROPERLY TIGHTENED ON THE INVOLVED VEHICLES. THE NUT COULD COME OFF DURING VEHICLE OPERATION.

Remedy: DEALER WILL TIGHTEN THE PITMAN ARM ATTACHING NUT TO THE CORRECT SPECIFICATIONS WITHOUT CHARGE TO OWNER.

Reported: 1977-10-25 (October 25, 1977)

ON THE INVOLVED VEHICLES, THE PARK ACTUATION SUPPORT PLATES ARE DEFECTIVE DUE TO THEIR SUSCEPTIBILITY TO CRACKING DUE TO IMPROPER HEAT TREATMENT DURING MANUFACTURE. AS A RESULT, FRAGMENTS FROM A BROKEN PLATE CAN BECOME LODGED IN THE TRANSMISSION PARKING PAWL MECHANISM. THIS COULD PREVENT THE TRANSMISSION PARKING PAWL FROM ENGAGING WHEN THE SELECTOR LEVER IS PLACED IN THE "PARK" POSITION, OR PREVENT THE PAWL FROM BEING DISENGAGED FROM THE PARK GEAR.

Remedy: THE DEALER WILL REPLACE THE PARK ACTUATION CAM SUPPORT PLATES, FREE OF CHARGE, ON ALL AFFECTED VEHICLES.

Reported: 1977-11-15 (November 15, 1977)

ON THE INVOLVED VEHICLES, LEAKAGE MAY OCCUR AT THE THREADED CARBURETOR-TO-FUEL FILTER CONNECTION ON THE SUSPECT CARBURETORS. THIS IS DUE TO AN IMPROPERLY MACHINED CARBURETOR FUEL INLET CONNECTION.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, WILL REPLACE THE CARBURETOR WITHOUT CHARGE TO OWNER.

Reported: 1978-01-30 (January 30, 1978)

SOME OF THE STEEL WHEELS ON THE INVOLVED VEHICLES MAY HAVE BEEN IMPROPERLY MANUFACTURED. THESE WHEELS, OVER A PERIOD OF TIME, COULD CRACK IN THE WHEEL RIM AREA THROUGH NORMAL OPERATION, WITHOUT PRIOR WARNING.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE WHEELS ON THE INVOLVED VEHICLES.

Reported: 1978-02-16 (February 16, 1978)

THE SHIFT SELECTOR REACTION SPRINGS MAY BE DEFORMED AS A RESULT OF IMPROPER INSTALLATION OF SELECTOR LEVERS DURING COLUMN BUILDUP. THUS THE LEVER MAY NOT BE ABLE TO BE MOVED INTO THE INSERT DETENTS LOCATED IN THE STEERING COLUMN ASSEMBLY. THIS COULD PREVENT THE "PARK" GEAR FROM BEING ENGAGED.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE SHIFT SELECTOR REACTION SPRING WITHOUT CHARGE TO OWNER.

Reported: 1978-05-15 (May 15, 1978)

THESE VEHICLES MAY BE EQUIPPED WITH STEERING LINKAGES ON WHICH COTTER PINS MAY NOT HAVE BEEN INSTALLED ON CASTELLATED NUTS TO SECURE THE STEERING DRAG LINK AND TIE-ROD CONNECTIONS. ALSO, THESE ATTACHING NUTS MAY NOT HAVE BEEN TIGHTENED TO SPECIFICATIONS. THIS COULD ALLOW LINKAGE SEPARATION.

Remedy: THE DEALER WILL PERFORM NECESSARY CORRECTIONS TO THE STEERING LINKAGE ATTACHMENTS.

Reported: 1978-08-07 (August 7, 1978)

THE DRIVER"S SIDE SHOULDER BELT RETRACTOR MOUNTING BRACKET ASSEMBLY CONTAINS A WELD NUT WHICH WAS IMPROPERLY ATTACHED TO THE BRACKET. THIS FAILS TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".

Remedy: THE DEALER WILL REPAIR THE LEFT SIDE SHOULDER BELT RETRACTOR MOUNTING BRACKET ON THE INVOLVED VEHICLES FREE OF CHARGE.