Volvo ACL recalls by model year

Reported: 2000-01-21 (January 21, 2000) · Model years: 1988, 1989, 1990, 1991, 1992, 1993

VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH FONTAINE FIFTH WHEEL ASSEMBLIES, MODELS SL5WMS6125, SL5WMS7125, SL5WMS8125, SL5WMS9125, SL5WMS10125, SL5APM6125, SL5APM7125, SLAPM8125, SL5APM9125, SL5APM10125, SL5WMS-D, SL5APM-D, AND SL5BPS-D. IMPROPER INSTALLATION OF THE FIFTH WHEEL ASSEMBLY CAN CAUSE CRACKING OF THE FIFTH WHEEL MOUNTING PLATE.

Consequence: UNDER THE TRAILER LOADING, THE MOUNTING PLATE COULD EVENTUALLY FAIL DUE TO FATIGUE.

Remedy: DEALERS WILL INSPECT AND REPLACE THE MOUNTING PLATES THAT ARE CRACKED.

Reported: 1995-11-13 (November 13, 1995) · Model years: 1994, 1995

UNDERCOATING APPLIED TO THE INSIDE OF THE CAB SHELL SQUEEZED OUT DURING ASSEMBLY ONTO THE BRAKE PEDAL PLUNGER.

Consequence: UNDERCOATING ON THE PLUNGER MAY CAUSE THE PLUNGER TO STICK RESULTING IN INCREASED BRAKE PEDAL EFFORT AND/OR SLOW RELEASE OF THE BRAKES INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL CLEAN THE UNDERCOATING FROM THE BRAKE PEDAL PLUNGER ASSEMBLY, LUBRICATE AND REINSTALL THE BRAKE PEDAL PLUNGER ASSEMBLY.

Reported: 1996-03-23 (March 23, 1996) · Model years: 1994, 1995, 1996

THE TRACTION SOLENOID EXHAUST CAN BE OBSTRUCTED DUE TO INADEQUATE DRAINAGE AND A BUILD-UP OF ROAD CONTAMINATION BETWEEN THE MOUNTING BRACKET AND THE SOLENOID HOUSING. THE OBSTRUCTED EXHAUST PREVENTS THE RELAY VALVE CONTROL AIR PRESSURE FROM VENTING AFTER A DIFFERENTIAL BRAKING TRACTION EVENT.

Consequence: THIS CONDITION WOULD KEEP THE REAR AXLE SERVICE BRAKES APPLIED WITHOUT ANY BRAKE PEDAL MOVEMENT BY THE DRIVER INCREASING THE RISK OF A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REMOVE THE SUSPECT VALVE AND INSTALL A NEW VALVE THAT HAS A MODIFIED SOLENOID HOUSING WHICH WILL ALLOW FOR SUFFICIENT DRAINAGE AND A NEW VALVE MOUNTING BRACKET WITH INCREASED HEIGHT TO REDUCE ENTRY OF CONTAMINATION.

Reported: 1998-10-14 (October 14, 1998) · Model years: 1994, 1995, 1996, 1997, 1998

VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE AIR SUSPENSION CONTROL VALVE SUPPLY LINE WAS NOT PLUMBED THROUGH AN AIR PRESSURE PROTECTION VALVE. IN THE EVENT OF A FAILURE, THERE WOULD BE LOSS OF AIR PRESSURE IN THE 'B' SYSTEM AIR RESERVOIR THAT SUPPLIES AIR PRESSURE FOR THE FRONT STEER AXLE BRAKES.

Consequence: THIS CONDITION WOULD RESULT IN INCREASED STOPPING DISTANCES.

Remedy: DEALERS WILL INSTALL THE NECESSARY AIR PRESSURE PROTECTION VALVE.

Reported: 1996-02-12 (February 12, 1996) · Model years: 1995

THE REAR SUSPENSION AXLE RETENTION PLATE CAN BREAK UNDER NORMAL USE, AFFECTING AXLE ALIGNMENT.

Consequence: THIS CONDITION COULD RESULT IN LOSS OF REAR AXLE STABILITY AFFECTING VEHICLE DIRECTIONAL CONTROL AND INCREASING THE POTENTIAL FOR A VEHICLE CRASH.

Remedy: DEALERS WILL REMOVE AND REPLACE THE AXLE RETENTION CLIP PLATES ON AFFECTED VEHICLES.

Reported: 1996-08-27 (August 27, 1996) · Model years: 1995

THE REAR MOST AXLE OF THE TANDEM AXLE SET COULD HAVE INOPERABLE BRAKES ON ONE OR BOTH WHEELS BECAUSE THE BRAKE S-CAM WAS INCORRECTLY INSTALLED.

Consequence: THIS CONDITION COULD CAUSE INCREASED STOPPING DISTANCE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL INSPECT THE BRAKE SYSTEM AND REPAIR THE S-CAM ASSEMBLY IF FOUND REVERSED.

Reported: 1996-02-22 (February 22, 1996) · Model years: 1996

VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 VEHICLES BUILT WITH A VOLVO 5.7 (12,500 LBS) FRONT STEERING AXLE. DUE TO HYDROGEN EMBRITTLEMENT, THE FRONT STEERING AXLE KING PINS COULD HAVE BROKEN DURING ASSEMBLY. CONTINUED OPERATION OF A VEHICLE WITH A BROKEN KING PIN COULD ALLOW THE PIN TO WORK LOOSE.

Consequence: THIS CONDITION CAN CAUSE ERRATIC STEERING RESULTING IN LOSS OF STEERING CONTROL INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL INSPECT THE VEHICLES FOR A BROKEN KING PIN AND REPLACE THE KING PINS IF BROKEN.

Reported: 2000-02-24 (February 24, 2000) · Model years: 1997, 1998

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH HALDEX MANIFOLD DASH VALVES (MDV) USED IN TRACTOR AND TRAILER PARKING BRAKES. THESE VALVES DO NOT MEET THE REQUIREMENTS OF FMVSS NO. 121, "AIR BRAKE SYSTEMS." A LOSS OF THE ISOLATION OF THE TWO BRAKE SYSTEM CIRCUITS CAN RESULT IN THE LOSS OF SERVICE BRAKES WHEN THERE IS ANOTHER FAILURE OF ONE OF THE TWO BRAKE CIRCUITS.

Consequence: THE LOSS OF SERVICE BRAKES CAN OCCUR, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL REPLACE THE SUSPECT VALVES.

Reported: 2000-08-22 (August 22, 2000) · Model years: 1997, 1998, 1999, 2000

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

Consequence: THIS CONDITION COULD CAUSE THE ABS ECU TO EXHAUST THE AIR AT THE AIR BRAKE MODULATORS FOR ONE OR MORE OF THE WHEELS. THIS COULD RESULT IN EXTENDED BRAKING DISTANCES AND A POSSIBLE CRASH.

Remedy: DEALERS WILL REPLACE THE ABS ECU.

Reported: 1997-11-17 (November 17, 1997) · Model years: 1997

VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE STEER AXLE WHEEL BEARING JAM NUT LOCK WASHER MAY NOT HAVE BEEN BENT OVER THE JAM NUT AFTER THE WHEEL BEARINGS WERE ADJUSTED.

Consequence: IF THIS CONDITION EXISTS, THE JAM NUT AND WHEEL BEARING ADJUSTING NUT CAN BACK OFF THE SPINDLE ALLOWING THE WHEEL AND THE BRAKE DRUM ASSEMBLY TO SEPARATE FROM THE VEHICLE INCREASING THE RISK OF A VEHICLE CRASH.

Remedy: DEALERS WILL INSPECT THE STEERING AXLE WHEEL BEARING JAM NUT LOCK WASHER TO DETERMINE IF IT IS BENT OVER THE JAM NUT, AND IF NOT, REPAIR AS REQUIRED.

Reported: 1998-05-19 (May 19, 1998) · Model years: 1997, 1998

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS.

Consequence: THIS CONDITION CAN CAUSE FAILURE OF THESE WHEELS.

Remedy: ACCURIDE/AKW WILL REPLACE THESE WHEELS.

Reported: 1998-11-17 (November 17, 1998) · Model years: 1997, 1998

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH A FAL 8.0 FRONT STEER AXLE. THE UPPER STEERING ARM CAN FAIL WITHOUT WARNING.

Consequence: THIS CONDITION CAN RESULT IN THE LOSS OF STEERING CONTROL, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT THE UPPER STEERING ARM AND REPLACE IT, IF REQUIRED.

Reported: 2000-01-18 (January 18, 2000) · Model years: 1999

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH A STEEL FUEL TANK. THE CLOSURE ONLY FUEL TANK CAP, INSTALLED ON THE STEEL FUEL TANK, FAILED WHEN THE TANK WAS DROPPED FROM A 10' HEIGHT AS REQUIRED BY FMVSS NO. 393, "LIQUID FUEL TANKS."

Consequence: FUEL LEAKAGE COULD OCCUR, INCREASING THE RISK OF A FIRE.

Remedy: OWNERS WILL BE PROVIDED WITH A NEW FUEL TANK CAP.

Reported: 2000-10-24 (October 24, 2000) · Model years: 1999

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW 20-EDL BALL-SOCKET ASSEMBLIES. CERTAIN OF THE BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET. THESE BEARINGS WERE PRODUCED BETWEEN JULY 5 AND OCTOBER 3, 1999.

Consequence: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE PARTIAL CONTROL OF THE RIGHT FRONT WHEEL, POSSIBLY RESULTING IN A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE BALL-SOCKET ASSEMBLIES.

Reported: 2001-05-08 (May 8, 2001) · Model years: 1999

VEHICLE DESCRIPTION: HEAVY DUTY, CLASS 8, TRUCKS EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.

Consequence: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE PARTIAL CONTROL OF THE RIGHT FRONT WHEEL, POSSIBLY RESULTING IN A CRASH.

Remedy: DEALERS WILL REPLACE THE DEFECTIVE BALL SOCKETS AND/OR DRAG LINKS. OWNER NOTIFICATION BEGAN DURING MAY 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLVO TRUCKS AT 1-800-528-6586.

Reported: 2000-11-20 (November 20, 2000) · Model years: 1999

VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 VEHICLES EQUIPPED WITH ARVINMERITOR AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS. THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.

Consequence: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE STEERING CONTROL, POSSIBLY RESULTING IN A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE BALL SOCKET ASSEMBLIES. THE CAMPAIGN HAS BEEN SUPERCEDED BY RECALL NO. 02V037002. OWNER NOTIFICATION BEGAN NOVEMBER 17, 2000. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLVO TRUCKS AT 1-800-528-6586.

Reported: 2002-08-15 (August 15, 2002) · Model years: 1999, 2000

ON SOME HEAVY DUTY CLASS 8 VEHICLES EQUIPPED WITH ARVINMERITOR AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS, THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.

Consequence: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE STEERING CONTROL, POSSIBLY RESULTING IN A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE BALL SOCKET ASSEMBLIES. THIS CAMPAIGN SUPERSEDES NHTSA CAMPAIGN NOS. 01V-139.001 AND 02V-037.002. OWNER NOTIFICATION BEGAN JULY 25, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLVO TRUCKS AT 1-800-528-6586.

Reported: 2001-01-29 (January 29, 2001) · Model years: 2000

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH ACCURIDE 22.5 X 8.25 15 TUBELESS DEMOUNTABLE RIMS, PART NO. 32051. CERTAIN RIMS CONTAIN A NON-FUSION AREA IN THE BUTT-WELD OF THE MOUNTING RING. UNDER CERTAIN CIRCUMSTANCES, THE DEFECT COULD DEVELOP INTO A CRACK ON THE MOUNTING RING.

Consequence: OVER TIME, THE CRACK COULD PROPAGATE AND IF NOT HEEDED, COULD RESULT IN MOUNTING RING FAILURE, POTENTIALLY CAUSING THE RIM TO SEPARATE FROM THE VEHICLE.

Remedy: ACCURIDE WILL INSPECT AND REPLACE THE DEFECTIVE OR SUSPECT WHEEL RIMS.

Reported: 2001-07-10 (July 10, 2001) · Model years: 2000

VEHICLE DESCRIPTION: HEAVY DUTY 6X4 TRUCKS EQUIPPED WITH CHALMERS 800 SERIES SUSPENSION KITS. THESE SUSPENSION KITS MAY HAVE INSUFFICIENT PENETRATION OF THE WELD ATTACHING THE TORQUE ROD EYE TO THE TORQUE ROD TUBE.

Consequence: FAILURE OF THE WELD COULD RESULT IN SEPARATION OF THE EYE AND TUBE, CAUSING A LOCK OF AXLE RETENTION, WHICH COULD RESULT IN LOSS OF VEHICLE CONTROL.

Remedy: DEALERS WILL REPLACE ALL CHALMERS FIXED TORQUE RODS ON THESE VEHICLES. CHALMERS IS CONDUCTING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHALMERS AT 1-905-624-9750.