Lincoln MARK V recalls by model year

Reported: 1976-09-14 (September 14, 1976) · Model years: 1977

Reported: 1977-09-13 (September 13, 1977) · Model years: 1977

THE INVOLVED VEHICLES WERE FITTED WITH TILT STEERING COLUMNS CONTAINING TRANSMISSION CONTROL INSERTS INTENDED FOR TRUCKS RATHER THAN PASSENGER VEHICLES. THIS MAY CAUSE THE TRANSMISSION SELECTOR POINTER TO BE MISALIGNED AND THE POSSIBILITY OF STARTING THE ENGINE WHEN THE SELECTOR IS BETWEEN THE NEUTRAL (N) AND DRIVE (D) DETENTS AND THE TRANSMISSION IS IN DRIVE.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE TRANSMISSION SHIFT CONTROL INSERT, WITHOUT CHARGE TO OWNER.

Reported: 1977-09-23 (September 23, 1977) · Model years: 1977, 1978

SOME OF THE INVOLVED VEHICLES MAY HAVE DEFECTIVE CARBURETORS IN WHICH, UNDER CERTAIN CIRCUMSTANCES, THE SECONDARY THROTTLE PLATES MAY STICK OPEN.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE CARBURETOR AT NO CHARGE TO OWNER.

Reported: 1979-11-16 (November 16, 1979) · Model years: 1977, 1978

THE INVOLVED VEHICLES WERE BUILT WITH AN ALUMINUM REAR BUMPER REINFORCEMENT ATTACHED TO TWO STEEL MOUNTING SURFACES. IN CLIMATES WHERE LARGE AMOUNTS OF ROCK SALT ARE USED, THE ALUMINUM REINFORCEMENT COULD EXPERIENCE CORROSION WHERE IT ATTACHES TO THE VEHICLE.

Remedy: DEALER WILL INSPECT ALL INVOLVED VEHICLES FOR DEGREE OF CORROSION. WHERE CORROSION IS SEVERE, THE ALUMINUM REINFORCEMENT WILL BE REPLACED WITH ONE MADE OF STEEL. WHERE CORROSION IS NOT SEVERE, DEALER WILL INSTALL INSULATION MATERIALS BETWEEN THE ALUMINUM AND THE STEEL COMPONENTS. THIS WILL BE DONE AT NO COST TO OWNER.

Reported: 1977-10-25 (October 25, 1977) · Model years: 1978

ON THE INVOLVED VEHICLES, THE PARK ACTUATION SUPPORT PLATES ARE DEFECTIVE DUE TO THEIR SUSCEPTIBILITY TO CRACKING DUE TO IMPROPER HEAT TREATMENT DURING MANUFACTURE. AS A RESULT, FRAGMENTS FROM A BROKEN PLATE CAN BECOME LODGED IN THE TRANSMISSION PARKING PAWL MECHANISM. THIS COULD PREVENT THE TRANSMISSION PARKING PAWL FROM ENGAGING WHEN THE SELECTOR LEVER IS PLACED IN THE "PARK" POSITION, OR PREVENT THE PAWL FROM BEING DISENGAGED FROM THE PARK GEAR.

Remedy: THE DEALER WILL REPLACE THE PARK ACTUATION CAM SUPPORT PLATES, FREE OF CHARGE, ON ALL AFFECTED VEHICLES.

Reported: 1978-11-27 (November 27, 1978) · Model years: 1979

THE INVOLVED VEHICLES WERE EQUIPPED WITH AUTOMATIC TRANSMISSIONS IN WHICH THE PARKING PAWL WAS NOT HEAT-TREATED. DURING NORMAL VEHICLE OPERATION, A PARKING PAWL THAT HAS NOT BEEN HEAT-TREATED COULD BECOME DEFORMED OR WORN TO THE POINT THAT THE TRANSMISSION WILL NOT LOCK IN "PARK". AS A RESULT, THE VEHICLE COULD ROLL FREE IF THE DRIVER DOES NOT SET THE PARKING BRAKE WHEN PARKING OR LEAVING VEHICLE UNATTENDED.

Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE PARKING PAWL WITH ONE THAT HAS BEEN HEAT-TREATED.

Reported: 1979-05-15 (May 15, 1979) · Model years: 1979

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Remedy: DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.