1994 Chevrolet K10: complaints, problems and recalls

WHILE DRIVING 20 MPH THE SPARE TIRE FELL OFF FROM UNDERNEATH THE VEHICLE. CONSUMER WAS ABLE TO MAINTAIN CONTROL OF THE VEHICLE, AND PULLED OVER. CONSUMER CONTACTED THE DEALER, AND WAS INFORMED THAT THE SPARE TIRE CABLE ASSEMBLY NEEDED TO BE REPLACED DUE TO CORROSION. *AK

Owner-reported narrative. Look up ODI 10076127 at NHTSA ↗

WHILE DRIVING IN INCLEMENT WEATHER WINDSHIELD WIPERS CAME ON AND OFF ON THEIR OWN. DEALER WAS AWARE OF THIS PROBLEM. MECHANIC INFORMED CONSUMER THAT THIS VEHICLE WAS NOT ON RECALL. CONSUMER INFORMED THE MECHANIC THAT THIS PROBLEM OCCURRED MORE THAN ONCE, AND HAD NOT BEEN RESOLVED. *AK

Owner-reported narrative. Look up ODI 10079666 at NHTSA ↗

TRANSMISSION FAILED EARLY

Owner-reported narrative. Look up ODI 713189 at NHTSA ↗

UPON RECEIPT OF RECALL NOTICE FROM MFR, CONSUMER CONTACTED DLR TO SCHEDULE APPT., DLR PUT VIN IN AND FOUND VEHICLE NOT INCLUDED IN RECALL, VEHICLE EXHIBITS SIMILAR DEFECT, BOTH BOLTS HAVE SHEARED OFF AND DRIVER'S SEAT IS IN RECLINING POSITION. *AK

Owner-reported narrative. Look up ODI 804703 at NHTSA ↗

DRIVER'S SEATBACK REST COLLAPSED DUE TO A BROKEN BOLT ON ASSEMBLY. HAD IT REPAIRED UNDER WARRANTY, BUT HAS BROKEN AGAIN. TRUCK WAS A RECALL, BUT DIDN'T RECEIVE A OWNER'S NOTIFICATION LETTER. *AK

Owner-reported narrative. Look up ODI 816403 at NHTSA ↗

WINDSHIELD WIPERS WENT OUT . A RECALL HAS BEEN ISUED. HOWEVER, THIS VEHICLE WAS NOT INCLUDED DUE TO VIN. THE DEALER HAS REPLACED THE WINDSHIELD WIPERS. *AK

Owner-reported narrative. Look up ODI 838499 at NHTSA ↗

DRIVER'S SEAT SEPARATED FROM THE TRACK. DEALER HAS INSPECTED VEHICLE. *AK

Owner-reported narrative. Look up ODI 862195 at NHTSA ↗

PURCHASE TRUCK NEW WHEN DRIVING THE TRANSMISSION IS HARD TO SHIFT TOOK TO DEALER COULDN'T FIND A PROBLEM . TT

Owner-reported narrative. Look up ODI 977204 at NHTSA ↗

Reported: 1993-09-15 (September 15, 1993)

THE BRAKE PEDAL PUSH ROD RETAINER IS MISSING, MISPOSITIONED OR NOT PROPERLY SEATED.

Consequence: BRAKE PEDAL PUSH ROD PROBLEMS CAN CAUSE THE STOP LAMPSWITCH AND THE BRAKE BOOSTER PUSH ROD TO DISCONNECT FROM THE BRAKE PEDAL,RESULTING IN LOSS OF BRAKE OPERATION, AND A VEHICLE CRASH COULD OCCUR WITHOUTPRIOR WARNING.

Remedy: INSPECT VEHICLES TO ASSURE THE BRAKE PEDAL PUSH ROD RETAINER IS PRESENT AND FULLY SEATED IN ITS CORRECT POSITION.

Reported: 1993-12-14 (December 14, 1993)

THE SEATS HAVE BEEN ASSEMBLED WITHOUT BOLTS THAT CONNECT THE UPPER SLAVE HINGE TO THE SEAT BACK FRAME, OR WITHOUT BOLTS THAT CONNECT THE SEAT TO THE SEAT ADJUSTER. IN EITHER CASE, THE VEHICLES FAIL TO CONFORM TO FNVSS NO. 207, "SEATING SYSTEMS."

Consequence: THE MISSING BOLTS MAY CAUSE THE DRIVER'S SEAT TO BECOMELOOSE AND IN A SUDDEN STOP OR ACCIDENT MAY SUBJECT THE OCCUPANT TO INCREASEDRISK OF INJURY.

Remedy: DEALERS WILL INSPECT SEATS FOR MISSING BOLTS AND INSTALL BOLTS IF REQUIRED.

Reported: 1994-04-05 (April 5, 1994)

TRUCKS WERE ASSEMBLED WITH THE LEFT-HAND LOWER CONTROL ARM TO FRAME REAR NUT TIGHTENED BELOW THE SPECIFIED TORQUE. LOW TORQUE ON THIS NUT MAY ALLOW THE ATTACHMENT BOLT TO LOOSED AND SUBSEQUENTLY FATIGUE AND BREAK. THE BOLT BREAKAGE CAN CAUSE THE LEFT HAND CONTROL ARM TO SEPARATE FROM THE FRAME.

Consequence: IF THIS OCCURS, A LOSS OF VEHICLE CONTROL AND A CRASH COULD RESULT.

Remedy: DEALERS WILL TIGHTEN THE LEFT-HAND LOWER CONTROL ARM TO FRAME REAR NUT TO THE PROPER TORQUE SPECIFICATION.

Reported: 1994-10-26 (October 26, 1994)

THE WINDSHIELDS WERE INSTALLED WITH INCORRECT WINDSHIELD OPENING PINCH-WELD-FLANGE PRIMER. THIS PRIMER WILL NOT PROPERLY ETCH THE PAINTED SURFACE OF THE FLANGE, ALLOWING THE WINDSHIELD TO SEPARATE FROM THE VEHICLE DURING A COLLISION. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 212, "WINDSHIELD MOUNTING."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: THE SEPARATION OF THE WINDSHIELD FROM THE VEHICLE DURING COLLISION INCREASES THE RISK OF INJURY FOR ALL PERSONS INVOLVED.

Remedy: DEALERS WILL REMOVE THE WINDSHIELD AND REINSTALL IT USING THE CORRECT PRIMER.

Reported: 1995-12-21 (December 21, 1995)

THE SEAT RECLINER TO SEAT FRAME ATTACHING BOLTS ON THESE VEHICLE COULD LOOSEN, FATIGUE AND FRACTURE, ALLOWING THE SEAT BACK TO SUDDENLY RECLINE.

Consequence: IF THIS WERE TO OCCUR TO THE DRIVER'S SEAT, THIS COULD RESULT IN A SUDDEN LOSS OF VEHICLE CONTROL INCREASING THE RISK OF A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REMOVE ALL FOAM AND/OR FABRIC SANDWICHED BETWEEN THE RECLINER ASSEMBLY AND THE SEAT FRAME, INSTALL WASHERS BETWEEN THE SEAT RECLINER AND THE SEAT FRAME AT EACH ATTACHMENT POINT, AND INSTALL NEW ATTACHING BOLTS TORQUED TO A HIGHER SPECIFICATION. THESE CORRECTIONS WILL BE MADE TO BOTH THE DRIVER'S AND PASSENGER'S SEATS.